Table of Contents
Advertisement
5. Set the Dest parameter to 147 Arp. You can select this Dest setting by selecting the Dest
parameter and typing in 147 followed by the Enter button.
6. Set the On Value parameter to 127, and the Off Value parameter to 0.
7. Lastly, set the Entry State parameter to On if you want the switch to be on by default
when the Multi is selected.
FX Page
The Forte SE contains Kurzweil's acclaimed effects processor, and when combined with Multi
Mode it puts the power of an entire studio of audio effects at your fingertips. This section
contains everything you'll need to know in order to use the Forte SE's effects in Multi Mode.
Press the FX soft button to enter the FX page.
Allocate FX
Program Insert
Allocate FX per channel
Use the Allocate parameter to enable or disable the Insert effects Chain of the Program in
each MIDI channel. (The MIDI channel for each Zone can be set on the Zone Main page.)
Each MIDI channel can be set to Y to enable Insert effects, or to N to disable Insert effects.
Use the Alpha Wheel or Value buttons to change between Y and N. Some MIDI channels set
to Y may be displayed as (Y). This means that there are not enough effects resources available
for that channel, and that channel's Insert effects are not loaded. If you want to use the Insert
effects Chain for a channel displayed as (Y), try setting other channels to N.
Program Insert
When each channel is selected, the Prog Insert field shows the name of the Insert Effects
Chain used by the selected channel. The Chain can be enabled or disabled using the "Allocate
FX per channel" section of the page. To edit or select a different Insert Effects Chain, the
Program must be edited in Program Edit mode.
Parameter
Y, N, (Y)
Effects Chain List (Appendix F)
Range Of Values
Multi Edit Mode
FX Page
Default Value
Y
No
11-29
Advertisement
Table of Contents
