Table of Contents
Advertisement
Multi Mode
The ARP Function
Saving a Split or Layer
After setting the Split/Layer parameters, the Split can be saved as a Multi so that it can easily
be recalled in Multi Mode. Press the Save button to the left of the display to begin the saving
process. See Save User Multis below for more details. Once you have saved your Split or
Layer as a Multi, you can edit controller assignments and other Multi parameters in Multi
Edit Mode (see
The ARP Function
Selecting the Arp soft button will bring up the Arpeggiator editor page Arp1. Arpeggiator
options and parameters are described in detail in
From Multi Mode, you can set Arpeggiators for each Zone in a Multi. The Arp soft button
also put you into Multi Edit mode, where you can access other editor pages.
For real-time control of Arpeggiator options, see
11-17
and
Save User Multis
Use the Save button to save a Split or Layer Multi as a User Multi (to save a changed
Zone Mute status, switch/button state, or slider state, you must set an entry value for each
controller in Multi Edit mode). Press the Save button once to view the Save Dialog. This will
allow you to specify the ID number to save to, and to rename the Multi if you wish. When
viewing the Save Dialog, you can quickly save the Multi to the displayed ID number by
pressing the Save button again.
10-12
Ch. 11 Multi Edit Mode
"Shift Key Number, Shift Key (ShKeyNum, ShiftKey)" on page 11-20.
for details).
"The Arpeggiator Function" on page 7-55.
"The Controller Destination List" on page
Advertisement
Table of Contents
