Table of Contents
Advertisement
Multi Edit Mode
ARP1 and ARP2 (Arpeggiator 1 & 2) Pages
Clock Source
With the Clock Source parameter, you can set the Forte SE—within the current Multi—to
generate its own tempo by setting Clock Source to Internal, or you can set the Forte SE to
sync up with the tempo from another device—assuming the device is sending MIDI clock
data to the Forte SE via MIDI or USB—by setting Clock Source to External. When Clock
Source is set to External, the Tempo parameter disappears from the display.
Aux FX Chan
The Aux FX Channel determines the FX channel through which the aux sends of all of the
zones in the current Multi are sent.
For example, if a zone 2 in a Multi has a program with 25 Basic Delay 1/8 as an Aux FX, and
zone 2 is assigned to channel 5, then setting the Aux FX Channel to 5 sends the programs of
all of the zones in the Multi through zone 2's Program's Aux FX (i.e., through 25 Basic Delay
1/8).
KB3 Channel
If KB3 Programs are selected for more than one Zone, this parameter specifies which MIDI
Channel has priority to load a KB3 Program. Only one KB3 Program can be loaded at a
time. You can set this parameter to a value between 1 and 16. If you want a KB3 Program to
play in a zone, you should set the KB3 channel to the channel of the Zone.
ARP1 and ARP2 (Arpeggiator 1 & 2) Pages
The Arpeggiator in Multi Mode is very similar to the Program Mode arpeggiator. See page
<?> in the Program Edit Mode Chapter for a full description of each arpeggiator parameter.
In Multi Mode, the Arpeggiator works the same as in Program Mode, except there is one
arpeggiator per Zone. The Arpeggiator in each Zone can each have different settings, and
they can be played at the same time. Also, in Multi Mode the Arpeggiator 1 page does not
have the Tempo parameter, instead the Tempo parameter on the Multi Common page should
be used.
For Most Factory Multis and Multis made by using the Split/Layer functions, the Arp On/
Off button is only assigned to control the Arpeggiator in Zone 1. To assign the Arp On/Off
button (or a different assignable switch) to control the Arpeggiator in other Zones, follow
these steps:
1. Go to the Multi Switches page and select ArpSwitch for the Switch parameter (or select a
different assignable switch if desired).
2. Use the Channel/Layer/Zone buttons to select the desired Zone.
3. Set the Mode parameter to MIDI CC.
4. Set the Type parameter to Toggled.
11-28
Advertisement
Table of Contents
