Table of Contents
Advertisement
INSTALLATION REQUIREMENTS
To ensure safety and proper machine performance, please note the
following before initial installation and whenever the machine is to be
relocated.
1.
The copier should be installed near an accessible power outlet
for easy disconnection.
2.
Be sure to connect the power cord only to a power outlet that
meets the specified voltage and current requirements.
Also make certain the outlet is properly grounded.
3.
Do not install the machine where it is:
damp or humid,
exposed to direct sunlight,
extremely dusty,
poorly ventilated,
subject to extreme temperature or humidity changes (e.g.,
near an air conditioner or heater).
4.
Ensure that the area chosen for the machine location is level.
5.
Be sure to allow the required space around the machine for
servicing and proper ventilation.
CAUTIONS
1.
Do not touch the photoconductive drum. Scratches or
smudges on the drum will cause dirty copies.
2.
The fusing area is extremely hot. Exercise care when in-
specting this area.
3.
Installation adjusters.
When moving the machine, be sure to release the instal-
lation adjusters. After moving the machine, turn the instal-
lation adjusters until they reach the floor to lock the ma-
chine.
Downloaded from:
http://www.usersmanualguide.com/
I
I
60cm
(23-5/8")
Fusing unit
Photoconductive
drum
30cm
(11-13/16")
60cm
(23-5/8")
120cm
(47-1/4")
Lock
Release
Adjuster
3
Advertisement
Table of Contents
