Interrupting A Copy Run - Sharp SF-1116 Operation Manual

INTERRUPTING A COPY RUN

INTERRUPT is used to interrupt a long copy run so that another job
can be done.
Reduction/enlargement/zoom, exposure adjustments, dual page
copying, margin shift, and edge erase can be selected during
interrupt copying.
An optional ADF can be used for interrupt copying.
Sort, group, and staple sort cannot be selected during interrupt
copying.
INTERRUPT will not function during staple sort copying (when an
optional staple sorter is installed).
%
%
%
%
%
ZOOM
%
%
%
2
1
4 5
8
7
0/ C
%
%
%
%
%
ZOOM
%
%
%
18
1 Press the INTERRUPT (
The copier will return to the initial settings.
If this copier has been programmed in the auditing mode using
user program No. 10, "–––" will appear in the copy quantity
display. Enter your account number using the 10-key pad. The
number of copies of the interrupt copying will be accumulated
against this account number. See page 33.
When an optional ADF is being used, the copier will stop after
completing the copying of the originals which have been fed into
the ADF. An original will be left on the document glass.
When the copier stops, remove the original from the
2
3
document glass and place the original for interrupt
copying on the document glass. Close the document
6
cover.
3 Select the desired available copier functions.
9
Set the number of copies.
4
5 Press the print (
C
6 When all INTERRUPT copies are finished, press the
INTERRUPT (
mode, and remove the original used for interrupt copying.
The previous copy quantity, copy ratio, copy density, and paper
size will be automatically reset.
7 Replace the original for the interrupted job and press the
print (
) key.
) button.
) key again to cancel the INTERRUPT
) button to resume copying.