Interrupting A Copy Run - Sharp AR-205 Operation Manual

INTERRUPTING A COPY RUN

INTERRUPT is used to interrupt a long copy run so that another job can be
done.
Sort or group cannot be selected during interrupt copying. (Sort and group
can be performed only if an optional electronic sortring kit and an optional
SPF or RSPF are installed.)
INTERRUPT will not function during two-sided copying.
Two-sided copying cannot be performed during INTERRUPT copying.
26
1 Press the INTERRUPT (
The copier will return to the initial settings.
If this copier has been programmed in the auditing mode using user
program No. 10, "–––" will appear in the copy quantity display. Enter
your account number using the numeric keys. The number of copies
of the interrupt copying will be accumulated against this account
number. See page 13.
When an optional SPF or RSPF is being used, the copier will stop after
completing the copying of the original which has been fed into the SPF
or RSPF.
2 When the copier stops, remove the original(s) and set
the original(s) for interrupt copying.
Select the desired available copier functions.
3
Set the number of copies.
4
5 Press the START (
The interrupt copies will be offset from the previous copies when user
program No. 19 is enabled. See page 39.
6 When all INTERRUPT copies are finished, press the
INTERRUPT ( ) key again to cancel the INTERRUPT
mode, and remove the original used for interrupt copying.
The previous copy quantity, copy ratio, copy density, and paper size
will be automatically restored.
Replace the original(s) for the interrupted job and press
7
the START ( ) key to resume copying.
) key.
) key.