Snmp Trap Support; Supported Standards And Rfcs; Table 6 Supported Snmp Traps - Nortel 2000 Using Manual

SNMP trap support

The Business Policy Switch supports an SNMP agent with industry-standard
SNMPv1 traps, as well as private SNMPv1 trap extensions

Table 6 Supported SNMP traps

Trap name
RFC 1215 (industry standard):
linkUp
linkDown
authenticationFailure
coldStart
warmStart
s5CtrMIB (Nortel proprietary traps):
s5CtrUnitUp
s5CtrUnitDown
s5CtrHotSwap
s5CtrProblem
s5EtrSbsMacAccessViolation
For information on configuring SNMP using the CI menus, refer to Chapter 3,
Using Web-based Management for the Business Policy Switch 2000 Software
Version 1.2, Reference for the Business Policy Switch 2000, Command Line
Interface Software Version 1.2, and Reference for the Business Policy Switch 2000
Management Software Version 1.2.

Supported standards and RFCs

This section lists the standards and RFCs supported by the BPS 2000.
Chapter 1 The Business Policy Switch 2000 83
Configurable
Per port
Per port
System wide
Always on
Always on
Always on
Always on
Always on
Always on
Always on
Using the Business Policy Switch 2000 Version 1.2
(Table
Sent when
A port's link state changes to up.
A port's link state changes to down.
There is an SNMP authentication failure.
The system is powered on.
The system restarts due to a management
reset.
A unit is added to an operational stack.
A unit is removed from an operational stack.
A unit is hot-swapped in an operational
stack.
An assigned base unit fails.
A MAC address violation is detected.
6).