Rate Limiting Configuration Screen; Table 35 Monitoring Modes - Nortel 2000 Using Manual

216 Chapter 3 Using the console interface

Table 35 Monitoring modes

Field
Port-based:
Disabled
-> Port X
Port X ->
<-> Port X
-> Port X or Port Y ->
-> Port X and Port Y ->
<-> Port X and Port Y <->
Address-based:
Disabled
Address A -> any Address
any Address -> Address A
<-> Address A
Address A -> Address B
Address A <-> Address B

Rate Limiting Configuration screen

The Rate Limiting Configuration screen allows you to limit the forwarding rate of
broadcast and multicast packets.
Figures
Configuration screens.
208700-B
Description
Default value for this feature.
Monitor all traffic received by Port X.
Monitor all traffic transmitted by Port X.
Monitor all traffic received and transmitted by Port X.
Monitor all traffic received by Port X or transmitted by Port Y.
Monitor all traffic received by Port X (destined to Port Y) and then
transmitted by Port Y.
Monitor all traffic received/transmitted by Port X and received/
transmitted by Port Y.
Default value for this feature.
Monitor all traffic transmitted from Address A to any address.
Monitor all traffic received by Address A from any address.
Monitor all traffic received by or transmitted by Address A.
Monitor all traffic transmitted by Address A to Address B.
Monitor all traffic between Address A and Address B (conversation
between the two stations).
79 and 80 show sample rate limiting values for the two Rate Limiting
Note: If a port is configured for rate limiting, and it is a MultiLink
Trunk member, all trunk member ports implement rate limiting. Also, if
a trunk member is implementing rate limiting and the port is disabled
from rate limiting, all trunk members are disabled from rate limiting.