Table 54 Ascii Configuration File Download Screen Fields - Nortel 2000 Using Manual

268 Chapter 3 Using the console interface

Table 54 ASCII Configuration File Download screen fields

Field
ASCII Configuration
Filename
TFTP Server IP Address
Retrieve Configuration
File from Server
Last Manual
Configuration Status
Last Auto Configuration
Status
Auto Configuration on
Reset
208700-B
Description
Enter the file name you have chosen for the ASCII configuration file. Choose a
meaningful file name that will allow you to identify the file for retrieval when
required. The file must already exist on your TFTP server and must be read/
write enabled.
Default Value Zero-length string
Range An ASCII string of up to 30 printable characters
The IP address of your TFTP load host.
Default Value 0.0.0.0 (no IP address assigned)
Range Four-octet dotted-decimal notation, where each octet is
represented as a decimal value, separated by a decimal
point
Specifies whether to retrieve the stored switch/stack ASCII configuration file
from the specified TFTP server (default is No). If you choose Yes, the
download process begins immediately and, when completed, causes the
switch/stack to be configured according to the CLI commands in the file.
Use the spacebar to toggle the selection to Yes.
Press [Enter] to initiate the process.
Default Value No
Range Yes, No
The system displays if the last manual configuration passed or failed.
Default Value Passed
Range Passed, Failed
The system displays if the last automatic configuration passed or failed.
Default Value Passed
Range Passed, Failed
Allows you to choose to Disabled, Use Configured, or Use BootP:
• Disabled—Auto configuration on reset is disabled.
• Use Configured—Use manually configured ASCII configuration filename
and TFTP server address for auto configuration on reset.
• Use BootP—Retrieve ASCII configuration filename, and optionally server
address, using BootP, when BootP is enabled, and perform auto
configuration on reset using these parameters.
Note: Refer to Appendix H for a sample BootP configuration file.
Default Value Disabled
Range Disabled, Use Configured, Use BootP