Spanning Tree Port Configuration Screen - Nortel 2000 Using Manual

Table 45 Spanning Tree Group Configuration parameters (continued)
Parameter Description
Delete VLAN Allows you to delete a VLAN from the specified spanning tree group.
Membership
Default Value
Range
Tagged BPDU Allows you to choose to send either tagged or untagged BPDUs from a tagged port.
on tagged port
Default Value
Range
STP Group Allows you to make the STP Group active or inactive.
State
Note that you cannot set the default STG, STG1, to InActive.
Default Value
Range

Spanning Tree Port Configuration screen

The Spanning Tree Port Configuration screen allows you to set the STG
participation for each switch port or all ports and to display spanning tree settings
for individual switch ports or all switch ports.
Figure 91
Configuration screens.
➨
Choose Spanning Tree Port Configuration (or press c) from the Spanning Tree
Configuration Menu to open the Spanning Tree Port Configuration screen.
Blank
1 to 4094; but only configured ones are available
NOTE: You cannot remove VLAN 1 from STP Group 1.
STP Group 1: No; Other STP Groups: Yes
No or Yes
Active for STG1; InActive for STGs 2 to 8.
Active or InActive
Note: If spanning tree participation of any trunk member is changed
(enabled or disabled), the spanning tree participation of all members of
that trunk is changed similarly.
shows sample port displays for the two Spanning Tree Port
Chapter 3 Using the console interface 245
Using the Business Policy Switch 2000 Version 1.2