238 Chapter 3 Using the console interface
Renumber Stack Units screen
The Renumber Stack Units screen
configured in the stack. When selected, this option identifies the unit number of
each unit in the stack configuration by lighting the corresponding number of (100
Mb/s port) LEDs on each unit for approximately 10 seconds. For example, unit 3
will display three LEDs.
To open the Renumber Stack Units screen:
➨
Choose Renumber Stack Units (or press n) from the main menu.
Figure 87 Renumber Stack Units screen
Current Unit Number
-------------------
[
1
]
[
2
]
[
3
]
[
4
]
Renumbering stack units will cause an automatic Reset to Current Settings to
occur across the entire stack.
the new numbering scheme. Check the stack configuration after the reset to
confirm the desired configuration is set.
Are you sure you want to renumber switches with the new settings?
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu.
208700-B
Note: This menu option and screen appears only when the switch is
participating in a stack configuration.
Renumber Stack Units
MAC Address
----------------------------
00-60-fd-77-a6-0c
00-60-fd-77-a5-f0
00-60-fd-77-a4-4c
00-60-fd-77-ab-84
The current configuration will be adapted to
(Figure
87) allows you to renumber the units
New Unit Number
---------------
Press Ctrl-C to return to Main Menu.
[
1
]
[
2
]
[
3
]
[
4
]
[ No
]