Figure 140 Installing An Mda - Nortel 2000 Using Manual

3
Insert the MDA into the Uplink/Expansion Module card guides
Make sure the MDA slides in on the card guides. Failure to align the MDA to
the card guides could damage the pins.

Figure 140 Installing an MDA

4 Press the MDA firmly into the Uplink/Expansion Module slot.
Be sure that the MDA is fully seated into the mating connector.
5
Secure the MDA by tightening the thumb screws on the MDA front panel.
6
Attach devices to the MDA ports.
After connecting the port cables, continue to follow the instructions in the manual
for the switch to connect power and verify the installation.
Note: The IEEE 802.3u specification requires that all ports operating at
100 Mb/s use only Category 5 unshielded twisted pair (UTP) cabling.
Appendix C Media dependent adapters 365
Using the Business Policy Switch 2000 Version 1.2
(Figure 140).
9793FA