Yamaha 2016 Grizzly yfm700gplg Service Manual page 69

1. Coolant reservoir hose
2. Radiator fan motor breather hose
3. Differential case breather hose
4. Ground lead
5. Coolant reservoir breather hose
6. Throttle body breather hose
7. TPS lead
8. Intake air pressure sensor lead
9. Final drive case breather hose
10. Speed sensor lead
11. AC magneto/crankshaft position sensor lead
12. Water pump breather hose
13. Radiator outlet hose
14. Differential motor lead
15. EPS torque sensor lead (for EPS models)
16. Air induction system solenoid lead
17. Shift control cable
18. Gear position switch lead
19. Reverse switch lead
20. Negative battery lead
21. Starter motor lead
22. Wire harness
23. Horn lead (except for CDN)
A. Face the end of the coolant reservoir breather
hose downward.
B. Pass the AC magneto/crankshaft position sensor
lead through the holder.
C. Fasten the radiator outlet hose to the frame with
the plastic band, making sure to face the end of the
band inward.
D. Place the differential motor lead and EPS torque
sensor lead (for EPS models) in the holder, and
then insert the ends of the holder into the hole in
the stay on the frame.
E. Route the differential case breather hose to the
inside of the frame.
F. Fasten the differential case breather hose to the
frame with the plastic band, making sure to face
the end of the band inward.
G. Connect the air induction system solenoid coupler
to the air cut-off valve assembly.
H. Attach the ground lead terminal to the frame using
the bolt.
I. Route the radiator fan motor breather hose,
differential case breather hose, and horn lead
(except for CDN) to the inside of the radiator outlet
hose.
J. Face the end of the plastic band inward.
K. For EPS models
L. Except for EPS models
M. Pass the hose and leads through the guide in the
order listed.
N. Route the final drive case breather hose above the
reverse switch lead and negative battery lead.
O. Route the speed sensor lead and AC
magneto/crankshaft position sensor lead above the
reverse switch lead.
P. Route the shift control cable below the gear
position switch lead, speed sensor lead, AC
magneto/crankshaft position sensor lead, and final
drive case breather hose.
2-38
CABLE ROUTING