Checking The Engine Mount; Checking The Constant Velocity Shaft Assembly Dust Boots; Checking The Engine Oil Level - Yamaha 2016 Grizzly yfm700gplg Service Manual

TIP
After adjusting the toe-in, the handlebar should
be centered.
Refer to "INSTALLING THE HANDLEBAR"
on page 4-50.
EBS30067

CHECKING THE ENGINE MOUNT

1. Check:
• Rubber damper
Cracks/damage → Replace.
• Engine mounting bolts
• Rubber damper nuts
Loosen → Tighten.
Refer to "ENGINE REMOVAL (3)" on page
5-8.
EBS30068
CHECKING THE CONSTANT VELOCITY
SHAFT ASSEMBLY DUST BOOTS
1. Check:
• Dust boots "1"
Damage → Replace.
Refer to "FRONT CONSTANT VELOCITY
SHAFT ASSEMBLIES, DIFFERENTIAL AS-
SEMBLY AND FRONT DRIVE SHAFT" on
page 8-4 and "REAR CONSTANT VELOCI-
TY SHAFT ASSEMBLIES, FINAL DRIVE
ASSEMBLY AND REAR DRIVE SHAFT" on
page 8-15.
A
1
B
1
A. Front
B. Rear
1
1
3-23
PERIODIC MAINTENANCE
EBS30038

CHECKING THE ENGINE OIL LEVEL

1. Place the vehicle on a level surface.
2. Check the engine oil level on a cold engine.
TIP
If the engine was started before the oil level was
checked, be sure to warm up the engine suffi-
ciently, and then wait at least 10 minutes until
the oil settles for an accurate reading.
3. Remove:
• Dipstick accessing cover
Refer to "GENERAL CHASSIS (4)" on page
4-11.
4. Check:
• Engine oil level
The engine oil level should be between the
minimum level mark "a" and maximum level
mark "b".
Below the minimum level mark → Add the
recommended engine oil to the proper level.
ECB01810
NOTICE
Do not allow foreign materials to enter the
crankcase.
TIP
Insert the dipstick completely into the oil filler
hole, and then remove it again to check the oil
level.
Recommended brand
YAMALUBE
Type
SAE 0W-30, 10W-30, 10W-40,
15W-40, 20W-40 or 20W-50
Recommended engine oil grade
API service SG type or higher,
JASO standard MA