Yamaha 2016 Grizzly yfm700gplg Service Manual page 174

d. Wipe off any excess rubber adhesive with a
clean rag.
EWB03690
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
4. Install:
• Handlebar switch (left)
• Rear brake master cylinder "1"
• Rear brake master cylinder holder "2"
Rear brake master cylinder hold-
er bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
TIP
• Align the end of the brake master cylinder hold-
er with the punch mark "a" on the handlebar.
• The "UP" mark "b" on the brake master cylinder
holder should face up.
• First tighten the bolt on the upper side of the
brake master cylinder holder, and then tighten
the bolt on the lower side.
2
b
5. Install (except for CDN):
• Horn switch "1"
Horn switch holder screw (except
for CDN)
0.5 Nm (0.05 m·kgf, 0.36 ft·lbf)
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
1
a
TIP
Be sure to fit the projection "a" on the handlebar
"2" between the ends of the horn switch.
1 2
a
6. Install:
• Front brake master cylinder "1"
• Front brake master cylinder holder "2"
▲▲▲
TIP
• Align the end of the brake master cylinder hold-
er with the punch mark "a" on the handlebar.
• The "UP" mark "b" on the brake master cylinder
holder should face up.
• First tighten the bolt "3" on the upper side of the
brake master cylinder holder, and then tighten
the bolt "4" on the lower side.
1
7. Install:
• Throttle lever assembly "1"
• Throttle lever assembly holder
TIP
Align the projection "a" on the throttle lever as-
sembly with the end of the brake master cylinder
holder "b".
4-51
HANDLEBAR
a
Front brake master cylinder hold-
er bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
2
a
b
4
2
1
3