EBS30365
REMOVING THE REAR WHEELS
1. Place the vehicle on a level surface.
2. Elevate:
• Rear wheels
TIP
Place the vehicle on a suitable stand so that the
rear wheels are elevated.
3. Remove:
• Rear brake calipers
TIP
Do not apply the brake lever and depress the
brake pedal when removing the brake calipers.
EBS30366
REMOVING THE REAR WHEEL HUBS
The following procedure applies to both of the
rear wheel hubs.
1. Remove:
• Wheel axle nut
Refer to "REMOVING THE FRONT WHEEL
HUBS" on page 4-21.
2. Remove:
• Rear brake caliper
TIP
Do not operate the brake lever or brake pedal
when removing the brake caliper.
EBS30367
CHECKING THE REAR WHEELS
The following procedure applies to both of the
rear wheels.
1. Check:
• Tire
• Wheel
Refer to "CHECKING THE TIRES" on page
3-16 and "CHECKING THE WHEELS" on
page 3-15.
2. Measure:
• Radial wheel runout
• Lateral wheel runout
Refer to "CHECKING THE FRONT
WHEELS" on page 4-21.
Over the specified limit → Replace the wheel
or check the wheel bearing play.
Refer to "REAR WHEELS" on page 4-23.
Radial wheel runout limit
1.2 mm (0.05 in)
Lateral wheel runout limit
1.2 mm (0.05 in)
3. Check:
• Wheel balance
Refer to "CHECKING THE FRONT
WHEELS" on page 4-21.
EBS30368
CHECKING THE REAR WHEEL HUBS
The following procedure applies to both of the
rear wheel hubs.
1. Check:
• Wheel hub "1"
Cracks/damage → Replace.
• Splines (wheel hub) "2"
Wear/damage → Replace.
1
EBS30369
INSTALLING THE REAR BRAKE DISCS
The following procedure applies to both of the
rear brake discs.
1. Install:
Brake disc
Rear brake disc bolt
30 Nm (3.0 m·kgf, 22 ft·lbf)
LOCTITE®
TIP
Install the brake disc so that the recessed por-
tion of the bolt hole faces away from the hub.
EBS30370
INSTALLING THE REAR WHEEL HUBS
The following procedure applies to both of the
rear wheel hubs.
4-24
REAR WHEELS
2