Selecting The Final Driven Pinion Gear Shim (Final Drive Case Cover Side) - Yamaha 2016 Grizzly yfm700gplg Service Manual

REAR CONSTANT VELOCITY SHAFT ASSEMBLIES, FINAL
e
If "-12" is stamped on the outside of the final
driven pinion gear,
"f" = 51.0 - 0.12
= 50.88
f
If "-05" is stamped on the outside of the final
driven pinion gear,
"g" = 24.0 - 0.05
= 23.95
"h" = 49.8
Therefore, shim and thrust washer thickness
"B" is 5.16.
"B" = 49.8 - (71.57 - 50.88 + 23.95)
= 5.16
Round off the hundredth digit and select the
appropriate shim(s).
In the example above, the calculated number
is 5.16. The chart instructs you to round off 6
to 5 at the hundredth place.
Thus, the shim and thrust washer thickness is
5.15 mm.
Hundredth
0, 1, 2
DRIVE ASSEMBLY AND REAR DRIVE SHAFT
g
Rounded value
0
8-27
Hundredth
3, 4, 5, 6, 7
8, 9
Shim and thrust washer are supplied in the
following thicknesses.
Final driven pinion gear shims (fi-
nal drive case side) "1"
Thickness (mm)
0.25 0.30 0.35 0.40 0.45 0.50
Thrust washer "2"
Thickness (mm)
4.50 4.80 5.10 5.40
TIP
Be sure to use one of each of the final driven pin-
ion gear shim (final drive case side) "1" and
thrust washer "2" to obtain the shim and thrust
washer thickness.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EBS30411
SELECTING THE FINAL DRIVEN PINION
GEAR SHIM (FINAL DRIVE CASE COVER
SIDE)
1. Measure:
• Final driven pinion gear thrust clearance "C"
C
Rounded value
5
10
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲