Self-Diagnostic Function And Diagnostic Code Table; Self-Diagnostic Function Table; Communication Error With The Meter; Diagnostic Code: Sensor Operation Table - Yamaha 2016 Grizzly yfm700gplg Service Manual

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE

EBS20086
SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
EBS30336

SELF-DIAGNOSTIC FUNCTION TABLE

Fault code
No.
Crankshaft position sensor: no normal signals are received from the crankshaft position sen-
12
sor.
13 Intake air pressure sensor: open or short circuit detected.
14 Intake air pressure sensor: hose system malfunction (clogged or detached hose).
15 Throttle position sensor: open or short circuit detected.
16 Throttle position sensor: stuck throttle position sensor is detected.
21 Coolant temperature sensor: open or short circuit detected.
22 Intake air temperature sensor: open or short circuit detected.
30 Latch up detected.
33 Ignition coil: open or short circuit detected in the primary lead of the ignition coil.
Component other than ISC (Idle Speed Control) unit is defective (ISC operating sound is
heard).
37
Defective ISC (Idle Speed Control) unit (ISC operating sound is not heard).
39 Fuel injector: open or short circuit detected.
41 Lean angle sensor: open or short circuit detected.
42 Speed sensor: no normal signals are received from the speed sensor.
43 Fuel system voltage: incorrect voltage supplied to the fuel injector and fuel pump.
44 EEPROM fault code number: an error is detected while reading or writing on EEPROM.
46 Charging voltage is abnormal.
Faulty ECU (Engine Control Unit) memory. (When this malfunction is detected in the ECU, the
50
fault code number might not appear.)
EBS30337

COMMUNICATION ERROR WITH THE METER

Fault code
No.
ECU (Engine Control Unit) internal malfunction (output signal error): signals cannot be trans-
Er-1
mitted between the ECU and the multi-function meter.
ECU (Engine Control Unit) internal malfunction (output signal error): no signals are received
Er-2
from the ECU within the specified duration.
ECU (Engine Control Unit) internal malfunction (output signal error): data from the ECU cannot
Er-3
be received correctly.
ECU (Engine Control Unit) internal malfunction (input signal error): non-registered data has
Er-4
been received from the meter assembly.
EBS30338

DIAGNOSTIC CODE: SENSOR OPERATION TABLE

TIP
The diagnostic code numbers cannot be displayed on the multi-function meter. To display the diagnos-
tic code numbers, use the Yamaha diagnostic tool.
Item
Item
10-7