Installing The Water Pump Housing; Installing The Water Jacket Joint - Yamaha 2016 Grizzly yfm700gplg Service Manual

3. Install:
• Impeller "1"
Impeller
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
After installation, check that the impeller shaft ro-
tates smoothly.
4. Install:
• AC magneto cover
Refer to "AC MAGNETO AND STARTER
CLUTCH" on page 5-35.
EBS30569

INSTALLING THE WATER PUMP HOUSING

1. Install:
• Water pump inlet hose "1"
• Clamps "2"
• Cooling water hose joint "3"
TIP
Tighten the clamp screw of each clamp "2" until
9 slots are visible in the area "a" of the clamp as
shown in the illustration. Position the screw head
of each clamp within the range shown in the il-
lustration.
b
a
2
3
1
b. Upward
EBS30471

INSTALLING THE WATER JACKET JOINT

1. Install:
• Clamps "1" (onto the water pump outlet hose)
1
45˚
a
2
• Water pump outlet hose "2" (onto the water
jacket joint)
• Water jacket joint "3"
TIP
Tighten the clamp screw of each clamp "1" until
4 slots remain in the area "a" of the clamp as
shown in the illustration.
Water jacket joint bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
3
b. Upward
6-13
WATER PUMP
1
2
1
b
a