Lubricating The Levers; Lubricating The Pedal; Adjusting The Drive Select Lever Control Cable And Shift Rod - Yamaha 2016 Grizzly yfm700gplg Service Manual

TIP
Hold the cable end upright and pour a few drops
of lubricant into the cable sheath or use a suit-
able lubricating device.
3. Apply:
• Lithium-soap-based grease
(onto end of the cable)
EBS30464

LUBRICATING THE LEVERS

Lubricate the pivoting point and metal-to-metal
moving parts of the levers.
Recommended lubricant
Silicone grease
EBS30465

LUBRICATING THE PEDAL

Lubricate the pivoting point and metal-to-metal
moving parts of the pedal.
Recommended lubricant
Lithium-soap-based grease
EBS30462
ADJUSTING THE DRIVE SELECT LEVER
CONTROL CABLE AND SHIFT ROD
ECB02700
NOTICE
Before moving the drive select lever, bring
the vehicle to a complete stop and return the
throttle lever to its closed position. Other-
wise the transmission may be damaged.
2
3
6
1. "N" (neutral)
1
4
5
7
PERIODIC MAINTENANCE
2. "H" (high)
3. "L" (low)
4. "R" (reverse)
5. "P" (park)
6. Drive select lever shift control cable
7. Drive select lever shift rod
1. Adjust:
• Brake pedal free play
Refer to "ADJUSTING THE REAR DISC
BRAKE" on page 3-12.
2. Remove:
• Handle mounted light cover
Refer to "REPLACING THE HANDLE
MOUNTED LIGHT BULB" on page 3-34.
• Side panel (left)
Refer to "GENERAL CHASSIS (1)" on page
4-1.
3. Adjust:
• Drive select lever shift control cable
• Drive select lever shift rod
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼
Drive select lever shift control cable:
a. Make sure that the drive select lever is in "N"
(neutral).
b. Squeeze the brake lever 15–25 mm (0.59–
0.98 in) "a", loosen the locknut "1", and then
adjust the shift control cable "2" with the ad-
juster "3" so that the drive select lever can be
shifted to "R" (reverse) from "N" (neutral), and
to "P" (park) from "R" (reverse).
a
3-32
▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
2
1
3
▼ ▼▼▼ ▼ ▼▼▼