Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe
green/yellow "1"
• Negative tester probe
black/white "2"
1
2
b. Move the fuel sender float to the minimum "3"
and maximum "4" level positions.
4
3
c. Measure the fuel sender resistance.
▲
▲▲▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
EBS30309
CHECKING THE SPEED SENSOR
1. Check:
• Speed sensor output voltage
Out of specification → Replace.
Output voltage reading cycle
0.6 V–4.8 V–0.6 V–4.8 V–0.6 V
R/L
B B/W
G/Y
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
ELECTRICAL COMPONENTS
▼
▼▼▼
▼ ▼▼▼
▼
a. Connect the pocket tester (DC 20 V) to the
speed sensor coupler as shown.
• Positive tester probe
white "1"
• Negative tester probe
black/blue "2"
b. Set the main switch to "
c. Elevate the rear wheels and slowly rotate
them.
d. Measure the voltage (DC 20 V) of white and
black/blue. With each full rotation of the rear
wheel, the voltage reading should cycle from
0.6 V to 4.8 V to 0.6 V to 4.8 V.
▲
▲▲▲
▲ ▲▲▲
▲
EBS30310
CHECKING THE RADIATOR FAN MOTOR
1. Check:
• Radiator fan motor
Faulty/rough movement → Replace.
▼
▼▼▼
▼ ▼▼▼
▼
a. Disconnect the radiator fan motor coupler
from the wire harness.
b. Connect the battery (DC 12 V) as shown.
• Positive battery terminal
blue "1"
• Negative battery terminal
black "2"
▲▲▲
9-94
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
W
L/Y
B
L /
" (on).
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼▼▼
1
L
W
B
L
/
2
▲ ▲▲▲
▲
▲▲▲
▼ ▼▼▼
▼
▼▼▼