Installing The Pitman Arm (Except For Eps Models); Installing The Pitman Arm (For Eps Models) - Yamaha 2016 Grizzly yfm700gplg Service Manual

b
4. Install:
• Steering stem bracket bolts "12"
(temporarily tighten)
5. Tighten:
• EPS unit bolts "9"
• Steering stem pinch bolts "11"
EPS unit bolt (for EPS models)
30 Nm (3.0 m·kgf, 22 ft·lbf)
LOCTITE®
Steering stem pinch bolt (for EPS
models)
35 Nm (3.5 m·kgf, 25 ft·lbf)
LOCTITE®
6. Tighten:
• Steering stem bolts "7"
Steering stem bolt
23 Nm (2.3 m·kgf, 17 ft·lbf)
TIP
• Bend the lock washer tabs "c" along a flat side
of the bolts.
• Pass the brake hoses through the cable guide.
Refer to "CABLE ROUTING" on page 2-33.
c
7. Tighten
• Steering stem bracket bolts "12"
Steering stem bracket bolt
51 Nm (5.1 m·kgf, 37 ft·lbf)
LOCTITE®
a
c
4-59
STEERING STEM
EBS30399
INSTALLING THE PITMAN ARM (except for
EPS models)
1. Install:
• Pitman arm "1"
• Washer
• Pitman arm nut
• Cotter pin
New
Pitman arm nut (except for EPS
models)
190 Nm (19 m·kgf, 137 ft·lbf)
TIP
• Align the groove "a" in the pitman arm with the
steering stem spline "b" that is indented.
• Install the washer so that the rubber side "c" of
the washer faces towards the pitman arm.
a
1
EBS30400
INSTALLING THE PITMAN ARM (for EPS
models)
1. Install:
• Pitman arm "1"
• Washer
• Pitman arm nut
• Cotter pin
New
Pitman arm nut (for EPS models)
210 Nm (21 m·kgf, 152 ft·lbf)
b
c
New