Changing The Engine Oil - Yamaha 2016 Grizzly yfm700gplg Service Manual

0 10 30 50
SAE 0W-30
SAE 10W-30
SAE 10W-40
–20 –10 0 10
ECB01820
NOTICE
• Engine oil also lubricates the clutch and the
wrong oil types or additives could cause
clutch slippage. Therefore, do not add any
chemical additives or use engine oils with a
grade of "CD" or higher and do not use oils
labeled "ENERGY CONSERVING II".
• Do not allow foreign materials to enter the
crankcase.
5. Check the engine oil level again.
ECB01830
NOTICE
Be sure the engine oil is at the correct level,
otherwise engine damage may result.
6. Install:
• Dipstick accessing cover
Refer to "GENERAL CHASSIS (4)" on page
4-11.
EBS30039

CHANGING THE ENGINE OIL

1. Start the engine, warm it up for several min-
utes, and then turn it off.
2. Remove:
• Dipstick accessing cover
Refer to "GENERAL CHASSIS (4)" on page
4-11.
3. Place a container under the engine oil drain
bolt.
4. Remove:
• Dipstick "1"
• Engine oil drain bolt "2"
(along with the gasket)
70 90 110 130 ˚F
SAE 15W-40
SAE 20W-40
SAE 20W-50
20 30 40 50 ˚C
PERIODIC MAINTENANCE
2
5. Drain:
• Engine oil
(completely from the crankcase)
6. If the oil filter cartridge is also to be replaced,
perform the following procedure.
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼
a. Remove the oil filter cartridge "1" with the oil
filter wrench "2".
Oil filter wrench
90890-01426
Oil filter wrench
YU-38411
b. Lubricate the O-ring "3" of a new oil filter car-
tridge with a thin coat of engine oil.
ECB01280
NOTICE
Make sure the O-ring "3" is positioned cor-
rectly in the groove of the oil filter cartridge.
c. Tighten the new oil filter cartridge to specifi-
cation with the oil filter wrench.
3-24
▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
2
▼ ▼▼▼ ▼ ▼▼▼
1