Installing The Tie-Rods; Installing The Front Arm Protectors - Yamaha 2016 Grizzly yfm700gplg Service Manual

Table of Contents

h. Install a new circlip.

INSTALLING THE TIE-RODS

The following procedure applies to both of the

Steering knuckle and tie-rod nut

25 Nm (2.5 m·kgf, 18 ft·lbf)

Pitman arm and tie-rod nut

25 Nm (2.5 m·kgf, 18 ft·lbf)

Install the tie-rod so that the groove "1" is on the

Refer to "ADJUSTING THE TOE-IN" on page

INSTALLING THE FRONT ARM

The following procedure applies to both of the

front arm protectors.

• Front arm protector "1"

Front arm protector bolt

7 Nm (0.7 m·kgf, 5.1 ft·lbf)

a. Fit the holders "a" on the front arm protector

onto the lower arm.

b. Tighten the bolt "b".

TIE-RODS AND STEERING KNUCKLES

Table of Contents