Printer Paper Jam - Xerox WorkCentre 220 User Manual

Hide thumbs Also See for WorkCentre 220:
Table of Contents

Advertisement

Maintenance
Message
PAPER JAM
INTERNAL TRAY
PRINTER ERROR XX
PAPER SIZE ERROR
PAPER JAM
UPPER RV MODULE
PAPER JAM
LOWER RV MODULE
CHECK PAPER TYPE
PAPER JAM
INSIDE

Printer paper jam

Inside the printer
Use the following procedure to remove any sheets of paper jammed inside the printer.
Caution -
sheet of paper is wrapped around the heat roller, do not try to remove it by yourself to avoid
injuries or burns. Switch off the machine immediately, and contact your Xerox Customer Support
Centre.
Open the front cover of the printer.
Remove the toner/drum cartridge set from inside the printer.
Open the cover.
Remove the jammed sheet from between the tray and the fusing unit.
Disconnect and reconnect the terminal.
If the problem persists, contact your supplier.
Check paper size (A4 / LETTER / ...).
Paper jam in top part of duplex module. Open the top access door of
the module and remove the jammed sheet.
Paper jam in bottom part of duplex module. Open the bottom access
door of the module and remove the jammed sheet.
Verify that the paper type used complies with manufacturer data (
refer to paragraph Characteristics, page 7-28).
Verify the paper size of the duplex module and check that it
corresponds effectively to manufacturer data (refer to paragraph
Characteristics, page 7-28).
Never touch a labelled area found on or near the heat roller. You can get burnt. If a
7-21
Action

Advertisement

Table of Contents
loading

Table of Contents