Xerox WorkCentre 220 User Manual page 48

Set the required coordinates with the numeric keypad or
Confirm your setting by pressing key OK.
The parameter is used to select the photocopy contrast. Adjust the contrast using
CONTRAST
keys and
You can also directly adjust the desired contrast using the key, press this key several times until
the required adjustment is obtained without using
The
LUMINOSITY
the brightness required using keys
Note -
All settings made using this menu become default settings of the machine.
Use keys or
Validate your setting by pressing the OK key.
Select or
NORMAL
Validate your setting by pressing the OK key.
Note -
When paper type is selected, the print speed is slowed down.
THICK
Note -
Use the manual feeder for paper with a weight greater than 90 g/m
Select the paper tray that you want to use;
.
Validate by pressing the OK key.
If you want to offset the side margins of your document to the left or to the right when scanning with
your scroll scanner.
Adjust the offset of the left/right margins (in 0.5mm steps) using keys
Validate by pressing the OK key.
If you want to offset the side margins of your document to the left or to the right when scanning with
your flat scanner:
Adjust the offset of the left/right margins (in 0.5mm steps) using keys
845 OK - ADVANCED FCT / COPY / CONTRAST
, then validate the choice with the OK key.
846 OK - ADVANCED FCT / COPY / LUMINOSITY
parameter is used to make your original document lighter or darker. Adjust
and
of the browser to scroll the setting described below that you want to modify.
851 OK - ADVANCED FCT / SCAN. & PRINT / PAPER
paper using keys
THICK
852 OK - ADVANCED FCT / SCAN. & PRINT / PAPER TRAY
AUTOMATIC
854 OK - ADVANCED FCT / SCAN. & PRINT / S.F MARGINS
855 OK - ADVANCED FCT / SCAN. & PRINT / FLATBED MARG
5-4
or .
845.
, then validate the choice with the OK key.
85 OK - ADVANCED FCT / SCAN. & PRINT
and .
2
.
, or
LOWER UPPER
Operation
using keys and
and .
and .