Duplex Printing (Depending On Model); Technical Parameters - Xerox WorkCentre 220 User Manual

D
UPLEX PRINTING
This function is only available if you have previously installed the duplex module and the additional
paper tray at the back of your terminal.
After installing the Duplex module at the back of your multi-function terminal, you can print faxes
received in two ways:
• SINGLE SIDED
• DOUBLE SIDED
All faxes received are printed according to the mode selected from the menu, no matter how the duplex
key is set.
To select the fax print mode :
Select the required option SINGLE SIDED or DOUBLE SIDED and validate your choice with
the OK key.
As delivered your fax is preset by default. However, you may adjust it to meet your requirements by
resetting the technical parameters.
To set the technical parameters:
Select the desired parameter and confirm with OK.
With the keys
press OK.
Parameter
1 - SCANNING
MODE
2 - TX HEADER
(
DEPENDING ON MODEL
T
ECHNICAL PARAMETERS
or , modify the parameter settings by following the table below and
Setting
1 - NORMAL Default value of the scan mode resolution for the documents
2 - FINE
to be transmitted.
3 - SFINE
4 - PHOTO
1 - WITH If this parameter is on, your header will appear on all
2 - WITHOUT
documents sent to your subscribers with your name, number,
date and number of pages.
Note: If you send a fax from the document loader, the
transmission header will not appear on the document your
correspondent receives.
4-8
Setting your machine
244 OK - SETUP / RECEPTION / DUPLEX
29 OK - SETUP / TECHNICALS
Signification
)