Specific Copy Settings; Scanner Settings - Xerox WorkCentre 220 User Manual

Operation
When the copy quality is no longer satisfactory, you can perform a calibration. To do so, refer to
paragraph Scanner calibration, page 7-17.
Moreover, a high number of controls let you improve the copy quality.

Scanner settings

The Resolution parameter adjusts the photocopying resolution. Select High Speed, Quality
or Photo resolution using keys
The zoom setting is used to reduce or enlarge part of the document by choosing the original
and the zoom value to apply to the document, 25 to 400 %. Enter the zoom value required
using the keys of the digital key pad. Validate the choice with the OK key.
The ASSEMBLED parameter is used to define the choice of your printer outputs; either
assembled or not assembled. Validate the choice with the OK key.
If you wish, you can change the origin of the scanner.
By entering new values of X and Y given in mm (X < 210 and Y < 286), you will move the
scanning zone as shown on the figure below.
Select the X and Y coordinates with keys
Set the required coordinates with the numeric keypad or
Confirm your setting by pressing key OK.
The
CONTRAST
keys
You can also directly adjust the desired contrast using the key, press this key several times until
the required adjustment is obtained without using
S
PECIFIC COPY SETTINGS
y
x
parameter is used to select the photocopy contrast. Adjust the contrast using
, then validate the choice with the OK key.
and
841 OK - ADVANCED FCT / COPY / RESOLUTION
or , then validate the choice with the OK key.
842 OK - ADVANCED FCT / COPY / ZOOMING
843 OK - ADVANCED FCT / COPY / ASSEMBLED
844 OK - ADVANCED FCT / COPY / ORIGIN
scanned area
Top view: scanned side down
or .
845 OK - ADVANCED FCT / COPY / CONTRAST
845.
6-15
or .