Up Mode Settings For Ieee 1394 - Ricoh B202 Service Manual

PRINTER OPTIONS

UP Mode Settings for IEEE 1394

Enter the UP mode. Then do the procedure below to perform the initial interface
settings for IEEE 1394. These settings take effect every time the machine is
powered on.
1. Press the "User Tools/Counter" key.
2. On the touch panel, press "System Settings".
3. Press "Interface Settings".
4. Press "IEEE1394".
5. Press following soft keys on the touch panel. Then set up the following settings:
• "IP Address"
Set the IP Address and Subnet Mask.
• "IP over 1394"
Enable or disable this setting as required. This setting enables IP over 1394
as the default setting for the printing method.
• "SCSI Print"
Enable or disable this setting as required. This setting enables SCSI Print as
the default setting for the printing method.
• "Bi-directional SCSI Print"
Switch bi-directional printing on or off for SCSI print.
SP Mode Settings for IEEE 1394
The following SP commands can be set for IEEE 1394.
SP No.
5839 004 Host Name
5839 007 Cycle Master
5839 008 BCR Mode
5839 009 IRM 1394a
Check
5839 010 Unique ID
5839 011 Logout
5839 012 Login
5839 013 Login MAX
B202/B178/B180
Name
Sets the name of the device used on the network.
Example: RNPXXXXXXXXXX
Enables or disables cycle master function of the IEEE
1394 standard bus.
Sets the BCR (Broadcast Channel Register) setting for
the Auto Node operation for the standard IEEE1394 bus
for when IRM is not in use. The following three settings
are available: "Standard," "IRM Color Copy," and
"Always Effective."
Determines whether an IRM check for IEEE 1394a is
conducted for the Auto Node when IRM is not used.
Enables the "Node_Unique_Id" setting for enumeration
on the standard IEEE 1394 bus.
Determines how successive initiator login requests are
handled during login in for SBP-2.
Enables or disables exclusive login for SBP-2.
Sets the limit for the number of logins for SBP-2. Range:
1 ~ 62.
Function
1-68 SM