Ricoh B202 Service Manual page 360

5816 [Remote Service]
5816 8 RCG Connect Timeout
5816 9 RCG Write Timeout
5816 10 RCG Read Timeout
5816 11 Port 80 Enable
5821 [Remote Service Address]
5821 1 CSS-PI Device Code
5821 2 RCG IP Address
5824 [NV-RAM Data Upload]
Uploads the UP and SP mode data (except for counters and the serial number) from
the NVRAM to a flash memory card.
5824 1 NV-RAM Data Upload
5825 [NV-RAM Data Download]
Downloads the UP and SP mode data from a flash memory card to the NVRAM
5825 1 NV-RAM Download
5828 [Network Setting]
5828 50 1284 Compatibility
(Centro)
5828 52 ECP (Centro)
5828 65 Job Spooling
5828 66 Job Spooling Clear: Start
Time
SM
*CTL
Specifies the connect timeout interval when calling the
RCG.
[1 to 90 / 10 / 1 second /step]
Specifies the write timeout interval when calling the
RCG.
[1 to 100 / 60 / 1 second /step]
Specifies the read timeout interval when calling the
RCG.
[1 to 100 / 60 / 1 second /step]
Enables/disables access via port 80 to the SOAP
method.
[0 or 1 / 0 / – ]
0: Disabled
1: Enabled
*CTL [ 0 to 4 / 0 / 1 /step] DFU
#
#
*CTL
Enables or disables 1284 Compatibility.
[0 or 1 / 1 / 1 / step]
0: Disabled, 1: Enabled
Enables or disables ECP Compatibility.
[0 or 1 / 1 / 1 / step]
0: Disabled, 1: Enabled
NOTE: This SP is activated only when SP5-828-50 is
set to "1".
Enables/disables Job Spooling.
[0 or 1 / 0 / 1 / step]
0: Disabled, 1: Enabled
Treatment of the job when a spooled job exists at
power on.
0: ON (Data is cleared)
1: OFF (Automatically printed)
5-63
COPY SERVICE MODE
B202/B178/B180