Up Mode Settings For Ieee 1394 - Ricoh B064 Service Manual

MFP OPTIONS: B064 SERIES

UP Mode Settings for IEEE 1394

Enter the UP mode and follow the procedure below to perform the initial interface
settings for IEEE 1394. These settings take effect every time the machine is
powered on.
1. Press User Tools/Counter.
2. On the touch panel, press System Settings.
3. Press Interface Settings.
System Intialization Settings
Select the desired settings.
Network
IP Address
Subnet Mask
IP Over 1394
SCSI Print
4. Press the key and enter the following settings:
• IP Address
• Subnet Mask
• IP Over 1394. Enable or disable this setting as required. This setting enables
IP Over 1394 as the default setting for the printing method.
• SCSI Print. Enable or disable this setting as required. This setting enables
SCSI Print as the default setting for the printing method.
• SCSI Print Bi-directional. Switch bi-directional printing on or off for SCSI print.
B064 Series/B140 Series/G126
Parallel Interface IEEE 1394
0000.0000.0000.0000
0000.0000.0000.0000
Enabled
Enabled
IEEE 802.1b
SCSI Print Bi-directional
1-92
End
On
B064I998.WMF
SM