Adjusting The Folding Unit Gear Phase - Ricoh B202 Service Manual

Adjusting the Folding Unit Gear Phase

If you remove gears from the folding unit, you must adjust the phase of the gears
when you reassemble the folding unit.
1. Arrange the folding rollers [A] and cam [B] as shown in the diagram.
2. Install the gears as follows:
• Align either of the two """ marks [C] on the cam gear with one of the """
marks [D] on the relay gear. The """ marks on the relay gear must be at one
o'clock [D] and five o'clock [E] respectively.
• Align the other """ mark on the relay gear [E] with the protruding plastic tab
("#") on the roller gear [F].
NOTE: When you have correctly installed the gears, the shorter teeth on the relay
gear [D] are at the upper right, and the longer teeth are at the lower left.
SM
[B]
[A]
B602R932.WMF
15
FOLDING UNIT
[C]
[D]
[E]
[F]
B602R994.WMF
B602