Front Scanner Wire - Ricoh B202 Service Manual

3.6.8 FRONT SCANNER WIRE

1. Front frame ( 3.6.5)
2. Front scanner wire clamp [A]
3. Front scanner wire bracket [B]
( x 1)
4. Front scanner wire and scanner
drive pulley [C] ( x 1)
Reassembling the Front Scanner Wire
1. Position the center ball [A]
in the middle of the forked
holder.
2. Pass the right end (with
the ring) [B] through the
square hole. Pass the left
end (with the ball) [C]
through the notch.
3. Wind the right end
counterclockwise (shown
from the machine's front)
five times. Wind the left
end clockwise three times.
NOTE: The two red marks [D] come together when you have done this. Stick
the wire to the pulley with tape. This lets you easily handle the
assembly at the time of installation.
SM
[A]
[C]
[C]
[A]
[D]
3-29
SCANNER UNIT
[B]
B178R539.WMF
[B]
B178R540.WMF
B202/B178/B180