Ricoh B202 Service Manual page 311

COPY SERVICE MODE
1902 [Paper Size] Tray Paper Size
1902 1 Tray 1 A4/LT
Specifies the paper size for tray 1.
1902 2 Tray 2 B4/LG
Specifies the paper size for tray 2.
1902 3 Tray 2 A4/LT
Specifies the paper size for tray 2.
1902 4 Tray 2 B5/LT
Specifies the paper size for tray 2.
⇒
1902 5 Fix Size
Turns On or Off auto paper size diction for the by-pass tray
1910 [Fusing Idling Time]
Specifies the timer for deciding whether to do fusing idling when receiving a print
command.
When receiving a new job within the time specified in this SP mode after the last job
is completed, fusing idling is not done because the fusing section was already
warmed up during the last job.
1910 1 Idling Time
B202/B178/B180
*BCU [0 or 1 / 0 / -] Alphanumeric
0: A4 sideways, 1: LT sideways
Tray 1 can only use these two sizes.
US: 1 FA
*BCU [0 or 1 / 0 / -] Alphanumeric
0: B4 lengthwise, 1: LG lengthwise
This specifies which size is detected for a
sensor output of 1101 (see section 6 for
details).
US: 1 FA
*BCU [0 or 1 / 0 / -] Alphanumeric
0: A4 lengthwise, 1: LT lengthwise
This specifies which size is detected for a
sensor output of 0110 (see section 6 for
details).
US: 1 FA
*BCU [0 or 1 / 0 / -] Alphanumeric
0: LT, 1: B5 lengthwise
This specifies which size is detected for a
sensor output of 1011 (see section 6 for
details).
*BCU [0 or 1 / 0 / -] Alphanumeric
0: OFF, 1: ON
ON: The by-pass tray automatically detects the
paper size and orientation. The process speed
is decreased to 1/2.
OFF: The by-pass tray does not detect the
paper size. The process speed stays at normal
speed.
*BCU [0 to 180 / 1 / 1 minute/step] DFU
5-14
Rev. 02/2006
SM