Muratec mfx-2200 User Manual page 73

4
5
6
7
IMPORTANT
We recommend using the envelopes as follows: DL (110mm×220mm), COM10
(104.8mm×241.3mm), Monarch (98.4mm×190.5mm), Envelope1 (90mm×205mm),
Envelope2 (240mm×332mm).
When you use the envelope in other sizes than shown above, set the size in the
custom size setting. For the custom size setting, refer to "Registering custom sizes"
(page 1-55).
NOTE
If the envelope is printed out wrinkled, take the following steps:
(1) R egister the envelop size so that the length is longer than the width in "Registering
custom sizes" (page 1-55).
(2) L oad the envelope into the bypass tray from the longer edge.
W hen the flap runs length-wise, be sure to load it into the bypass tray from the
(3) Select the custom paper registered as (1) in "Paper Size".
8
9
NOTE
When you set the paper size to "DL", "COM10", "Monarch", "Envelope1", or "Envelope2",
the paper type is automatically set to "Envelope".
10
DB2-90290-60.indb 53
The paper setting screen is displayed when you load paper in the
bypass tray.
Bypass [Others] Paper
Paper Size:A4
Paper Type:Plain
Close
Select "Paper Size" using the cursor keys and press [Edit].
Select "Other" using the cursor keys and press [Enter].
Select the appropriate paper size using the cursor keys and press
[Enter].
side including the flap.
Select "Paper Type" using the cursor keys and press [Edit].
Select "Envelope" using the cursor keys and press [Enter].
Paper Type
Plain Postcard
PasteBrd. Envelope
OHP
Cancel
Press [Close] to return to the standby screen.
Edit
Enter
Paper
1
1-53
2007/02/02 12:31:47