Error message
Please wait
Preparing
Press [Stop] to exit the
doc.
Printer In Use
Ratio is set to 100%
Relay Box
Replace drum cartridge
Rotate the document 90
deg or set the ratio
Rx doc. Stored
Secure Box
Secure Rx is canceled
Set the document and
press [Start].
From Page :
System stabilization is
needed. Turn power off
and on
The value exceeds limit.
Enter a value within
range.
Toner is almost empty.
Toner is empty
9-26
DB2-90290-60.indb
26
Countermeasure
The machine is getting ready. Wait for a while until the
operation is available.
The printer is not ready for printing. When it is ready
to print, the message will disappear. Please wait for a
while.
Scanning was canceled in the middle of the process due
to the memory overflow or by pressing <Stop>. Press
<Stop> to discharge all the documents.
You tried to print a list etc. during printing. Wait until
the current printing ends.
If you set the paper selection to auto when setting the
magnification to auto, the magnification will be set to
100%.
A box specified when you store, delete or print the
F-code document has been set as a relay box.
The drum cartridge is empty. Replace with a new drum
cartridge. Be sure to replace with an unused drum
cartridge. If you replace with a used drum cartridge,
the error message will not disappear.
Copying cannot be performed in the specified
document direction. Rotate document 90° or re-set the
magnification.
You tried to set the protect passcode for the security
reception to 0000 (cancel) when you received
documents. After printing all the received documents,
cancel the security reception.
A box specified when you store or delete the F-code
document has been set as a security box.
Documents received in the security reception were
printed.
After printing, the security reception settings will be
cancelled.
This message is displayed when no document remains
on the ADF after a document jam is released.
Load the documents from the page displayed, and
press <Start>. The following documents will be stored.
The system is unstable. Turn OFF the power switch,
and wait for three seconds or more before turning ON
again. If the same message appears again, contact your
authorized Muratec dealer.
A wrong number was entered.
Enter the correct value.
The toner becomes low. Get a new toner cartridge
ready.
Toner ran out. Replace the toner cartridge.
Reference
page
—
—
—
—
—
4-32,
4-34,
4-36
9-2
—
6-16
4-32,
4-36
6-16
9-17
—
—
9-2
9-2
2007/02/02
12:34:25