Special Dialing Characters - Muratec F-300 User Manual

Special dialing characters

Your machine allows you to enter special dialing characters when registering the autodi-
aler. The chart below briefly describes each of these characters. It also tells you how to
store those characters in your autodialer.
Character Description
Each pause lasts two seconds.
If you must wait for another dial tone or signal at
/P
any point in the dialing sequence, enter a pause.
(You can change the pause length. See page 10-6.)
– Makes long numbers easier to be read.
Switches from pulse-dialing to tone-dialing.
/T No need to use this character when using a tone
line.
Enters a "Dial prefix code" to access the alternative
/N telephone network.
"/N" must be entered before the first of number.
NOTE: For details on how to assign "Pause /Dial Opt." to a soft key, see page 8-2.
"Pause/Dial Opt." is defaulted to a soft key in F-300.
Keystroke
Press [Advanced Functions]
repeatedly until "Pause /Dial
Opt." appears, then press
[Enter].
– or –
Press once the soft key that
"Pause /Dial Opt." is assigned
to.
Press [Advanced Functions]
repeatedly until "Pause /Dial
Opt." appears, then press
[Enter]. Repeat this proce-
dure until the "–" character
appears on the LCD.
– or –
Press the "Pause /Dial Opt."
soft key twice.
Press [Advanced Functions]
repeatedly until "Pause /Dial
Opt." appears, then press
[Enter]. Repeat this proce-
dure until the "/T" character
appears on the LCD.
– or –
Press the "Pause /Dial Opt."
soft key until a "/T" appears.
Press [Advanced Functions]
repeatedly until "Dial Prefix
(/N)" appears and press
[Enter]. Repeat this proce-
dure until the "/N" character
appears on the LCD.
– or –
Press the "Pause /Dial Opt."
soft key until "/N" appears.
A & D
UTODIALLER IALLING OPTIONS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
3-3