Before Copying; Document And Paper Handling; Changing Your Machine To The Copy Mode; Display In The Copy Standby Mode - Muratec F-300 User Manual

Before copying

Document and paper handling

Before you begin making copies, please read the information mentioned on pages 2-10 to
2-16.

Changing your machine to the Copy mode

Press the [COPY

Display in the copy standby mode

Press [COPY
(For MFX-1330, Copy mode is the default standby mode.)
When the machine is in the Copy mode, the machine shows:
Copy Ready
Auto
To change the settings, refer to "Basic copy settings" on page 7-4.
Memory overflow message
If you have stored too much information in your machine's memory, a "Memory Over-
flow" message will appear on the LCD:
Memory Overflow
Start or Cancel
This appears because (1) too many pages have been stored in the memory, or (2) the
stored pages have too much information for your machine to remember.
If this message appears, press [Start] to tell your machine to copy as many pages into
memory, or press [Cancel] to delete the current job from memory (but not previous opera-
tions).
NOTE: If the machine is idle for 3 minutes it will automatically print the document stored in the
memory during the current operation.
7-2 C
OPYING
FAX SCAN] key until the COPY light glows.
 
FAX SCAN] to change the machine to the copy mode.
 
01
Ltr 100%
Document size
Recording paper size
Number of copies
Zoom ratio