Making Copies; Making Copies Using The Adf; Making Copies Using The Document Glass - Muratec F-300 User Manual

Making copies

Making copies using the ADF

1
Switch the machine to copy mode by pressing [COPY
Copy Ready
Auto
2
Place your document face up on the ADF and adjust the document guides to the docu-
ment size.
3
As needed, set the copy settings including the document type and scanning contrast,
number of copies, zoom ratio and sort setting. See "Basic copy settings" on page 7-4.
To clear the settings, press [Reset].
4
Press [Start] to begin copying.
To stop copying, press [Stop].

Making copies using the document glass

The document glass is available only for the MFX-1330.
1
Switch the machine to copy mode by pressing [COPY
Copy Ready
Auto
2
Make sure that there is no document on the ADF. If a document is on the ADF, it
takes priority over the document on the document glass.
3
Place your document face down on the document glass and align it to the upper left
corner. Then close the platen cover.
4
Press [Doc. Size] to select the document size, Letter, Half-letter
5
As needed, set the copy settings including the document type and scanning contrast,
number of copies, zoom ratio and sort setting. See "Basic copy settings" on page 7-4.
To clear the settings, press [Reset].
6
Press [Start] to begin copying.
To stop copying, press [Stop].
01
Ltr 100%
01
Ltr 100%
FAX SCAN].
 
FAX SCAN].
 
or Legal.
C
OPYING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
7-3