Plug In And Power Up; Turning Off The Transport Mode - Muratec F-300 User Manual

Plug in and power up

1
Plug the non-pronged end of the supplied AC power cord into the AC socket on the
machine and the pronged end into a properly grounded AC outlet.
IMPORTANT: Be sure not to turn the power on until after you have unlocked the scanner unit.
(See page 1-7.)
2
Turn on the power switch. The markings are international standards:
I means on, O means off.
It will take a few seconds for the machine to warm up. The machine will show:
Warming up
The machine will then show:
The following display will not appear on the F-300.
Mirror Locked
To use the machine, turn off the transport mode.
NOTE: While the power is on, the scanner lamp will always lights, but this does not mean
machine failure. See also "Scanner Sleep" on page 10-4.

Turning off the transport mode

When the machine is in the transport mode, the machine will show:
Mirror Locked
To turn off the transport mode:
1
Press [Menu], [ ], [1], [4].
Mirror Locked
2
Press [ ] or [ ] to select "Off" and press [Enter].
The scanner unit will move to home position and the machine will be ready to use.
IMPORTANT: • The transport mode will not appear on the F-300.
• If you must move the machine, turn this mode to on, then power off and lock the
scanner unit by sliding the lock switch.
:On
 
/ /Enter
L & I
AYOUT NSTALLATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
1-11