Initial Setup; Clearing Stored Settings; Getting Started - Muratec F-300 User Manual

Initial setup

Clearing stored settings

Before using your machine, clear the built-in user data. This ensures that the memory
will hold only your settings.
IMPORTANT: After specifying the initial settings, do not clear the memory again without an
authorized technician's advice.
To clear the memory:
1
Press [Menu], [ ], [0], then [2].
Clear User Settings
Yes  Enter
2
If you want to clear the memory, press [Enter].
If you do not want to clear the memory, just press [Cancel].

Getting started

In some countries you are required by law to indicate your name and fax number on
every fax you send.
YOU MUST THEREFORE STORE YOUR NAME (OR COMPANY NAME) AND
FAX NUMBER IN YOUR MACHINE BEFORE USING IT.
Every fax page you send arrives at the receiving machine with a single line of text at
the very top of the page. This text lists a name, called the Transmit Terminal Identifier
(TTI), and a fax number.
Under "Specifying initial settings" below, you can stored the following items including
your name and fax number.
• Language
• Current date and time
• Automatic daylight saving time detection
• Fax reception mode
• Dial tone detection
• Phone dialing type
• Your fax number
• TTI 1 / TTI 2 / TTI 3
• Usual TTI
• Idle time before switching to the Energy Save mode
The settings you adjust here can always be changed later.
Clear User Settings
No  Cancel
L & I
AYOUT NSTALLATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
1-13