Plug In And Power Up; Turning Off The Transport Mode - Muratec PLAIN-PAPER DIGITAL FAX/COPIER/PRINTER/SCANNER MFX-1330 User Manual

Plug in and power up

1
Plug the non-pronged end of the supplied AC power cord into the AC socket on the
machine and the pronged end into a properly grounded AC outlet.
IMPORTANT: Be sure not to turn the power on until after you unlocked the scanner unit locking
switch. (See page 1.7.)
2
Turn on the power switch. The markings are international standards:
I means on, O means off.
It will take a few seconds for the machine to warm up. The machine shows:
Warming up
Then the machine shows:
The following display doesn't appear in F-300 model.
Mirror Locked
To use the machine, turn off the transport mode.
NOTE: While the power is on, the scanner lamp will always light, but this is not machine
failure, it is needed to prolong the life of your machine's scanner lamp.

Turning off the transport mode

When the machine is in the transport mode, the machine shows:
Mirror Locked
To turn off the transport mode:
1
Press
MENU
Mirror Locked
2
Press
The scanner unit will move to home position and the machine is ready to use.
IMPORTANT: • The transport mode doesn't appear in F-300 model.
• If you must reship the machine, turn this mode to on, then power off and lock the
scanner unit by sliding the lock switch.
, , 1, 4.
:On
 
/ /Enter
or to select "Off" and press .
ENTER
L & I
AYOUT NSTALLATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
1.11