FujiFilm FINEPIX S9100 Service Manual page 78

4. Adjustments
<Step 6>
FinePix S9100_9600_W adjustment item select screen
0. [ R ] : Flash memory reset
1. [ F 9 ] : AF Sensor Adjustment
2. [ F 4 ] : CCD Data Input
3. [ F 5 ] : Camera Adjustment
4. [ C ] : CCD Line Defect Adjustment
5. [ S ] : Shading Compensation Adjustment
6. [ F 6 ] : AF Adjustment
7. [ F 7 ] : Flash Adjustment
8. [ F 1 ] : Battery Voltage Adjustment
9. [ F 2 ] : Mode Dial Adjustment
10. [ F11 ] : Video Adjustment
11. [ F12 ] : End Setting
[ F 8 ] : Firmware Download
[ X ] : Restart
<Note>
(1) 'FxS9100_9600 W PC Soft Ver.1.00' at the bottom-right of the screen indicates the version number of the adjustment
software.
(2) After running firmware download, other adjustments may be required depending on the content of the download software.
In such cases, the items to be adjusted, and the sequence of adjustment, will be indicated separately.
(3) After starting the adjustment software and beginning communication with the camera, always run End Setting following
adjustment and before returning the camera to the customer. If the End Setting is not run, the PC will not recognize the
camera when the two are connected.
Reason: As the camera will remain in the Jig mode (repair mode), it will not be recognized with the normal camera drivers.
(4) Pressing the [X]:Restart key interrupts adjustment and returns you to the "Notes on using the adjustment software" screen.
However, the camera will still not be recognized as Mass Storage.
4-10
*Only use for when the MAIN PWB has been replaced.
[Execute this item only when
need to change the firmware.]
FinePix S9100/S9600 Service Manual
FxS9100_9600 W PC Soft Ver.1.00
<Fig. 4-7-5>