FujiFilm FINEPIX S9100 Service Manual page 74

4. Adjustments
<Step 3>
Select the "EVR&Comm." tab ([1] in Fig. 4-6-3) in the
"Customize" dialog box that appears.
Set the "EVR&Comm." items as follows.
Item
etc (-V2) Check
LANC page Check
<Step 4>
Select the "Etc" tab ([1] in Fig. 4-6-4) in the "Customize"
dialog box that appears.
Set the "Etc" items as follows.
Item
# of auto measure 0
Change mode Do not check
[Note]
If [Disable OKNG display] on the PC screen (Fig. 4-6-4) is
set to OFF, the PC screen displays [OK] if adjustment is OK,
and [NG] if adjustment is NG (either setting is OK).
<Step 5>
Select the "Hardware" tab ([1] in Fig. 4-6-5) in the
"Customize" dialog box that appears.
Input the values for PI/O port ([2] in Fig. 4-6-5).
PIO 0 10
PIO 1 11
Set the "Hardware" items ([3] in Fig. 4-6-5) as follows.
Item
Debug Mode Select [Default]
<Step 6>
Once the above settings have been made, click on "Apply"
([4] in Fig. 4-6-5) in the "Customize" dialog box to complete
setup.
This applies the setup, therefore setting is unnecessary from
the next time forward.
4-6
Details
Details
12 14 16
13 15 17
Details
FinePix S9100/S9600 Service Manual
(2) (1)
<Fig. 4-6-3>
(2)
<Fig. 4-6-4>
(1)
<Fig. 4-6-5>
(2)
(3) (4)