FujiFilm FINEPIX S9100 Service Manual page 75

FinePix S9100/S9600 Service Manual
[ Setting when S9000/9500 Zoom drive jig is used ]
Always use this jig for AF adjustment.
But it can be used for either manual or automatic adjustment for CCD Line Defect and shading.
A zoom drive jig is not required for manual adjustment.
If no zoom drive jig is connected, leave the [Define (-F)] field blank. (If the [AUTO] setting is used, an error occurs when the
calibration software is launched.)
<Step 7>
Select the "Compile" tab ([1] in Fig. 4-6-6) in the "Customize"
dialog box that appears.
Set the "Compile" items as follows.
Item
Define(-F) AUTO
Compile data Do not check
<Step 8>
Select the "RS232C" tab ([1] in Fig. 4-6-7) in the "Customize"
dialog box that appears.
Item
Port: COMX (Port connected with PC)
Baudrate: 19200
Bytes: 8
Stop: 1
Parity: no
Open when start: Check
<Step 9>
Once the above settings have been made, click on "Apply"
([3] in Fig. 4-6-7) in the "Customize" dialog box to complete
setup.
Details
Details
4. Adjustments
(1) (2)
c:\finepixs9100_9600_w\fxs9100_9600_
c:\documents and settings\xxxxxxx
<Fig. 4-6-6>
(2)
<Fig. 4-6-7>
(1)
(3)
4-7