Yamaha e60hmhd Service Manual page 102

TIGHTENING TORQUES
Nut (A) Nut (B)
8 mm M5
10 mm M6
12 mm M8
14 mm M10
17 mm M12
General torque
specifications
N•m kgf•m ft•lb
5 0.5 3.6
8 0.8 5.8
18 1.8 13
36 3.6 25
43 4.3 31
GENERAL TORQUES
This chart specifies tightening torques for
standard fasteners with a standard ISO
thread pitch. Tightening torque
specifications for special components or
assemblies are provided in applicable
sections of this manual. To avoid warpage,
tighten multifastener assemblies in a
crisscross fashion and progressive stages
until the specified tightening torque is
reached. Unless otherwise specified,
tightening torque specifications require
clean, dry threads. Components should be at
room temperature.
2-13
E