Suzuki Swift Sport 2004 Service & Repair Manual page 17

4) Using continuity check or voltage check the following
procedure, check the wire harness for open circuit
and poor connection with its terminals. Locate
abnormality, if any.
1. Looseness of crimping
2. Open
3. Thin wire (single strand of wire)
Continuity Check
1) Measure resistance between connector terminals at
both ends of the circuit being checked (between "A-
1" and "C-1" in the figure). If no continuity is indicated
(infinity or over limit), that means that the circuit is
open between terminals "A-1" and "C-1".
2) Disconnect the connector included in the circuit
(connector-B in the figure) and measure resistance
between terminals "A-1" and "B-1".
If no continuity is indicated, that means that the
circuit is open between terminals "A-1" and "B-1". If
continuity is indicated, there is an open circuit
between terminals "B-1" and "C-1" or an abnormality
in connector-B.
Voltage Check
If voltage is supplied to the circuit being checked, voltage
check can be used as circuit check.
1) With all connectors connected and voltage applied to
the circuit being checked, measure voltage between
each terminal and body ground.
a) If measurements were taken as shown in the
figure and results were as listed in the following,
it means that the circuit is open between
terminals "B-1" and "A-1".
I2RH01010051-01
Voltage between
"C-1" and body ground: Approx. 5 V
"B-1" and body ground: Approx. 5 V
"A-1" and body ground: 0 V
b) Also, if measured values were as listed in the
following, it means that there is a resistance
(abnormality) of such level that corresponds to
the voltage drop in the circuit between terminals
"A-1" and "B-1".
Voltage between
"C-1" and body ground: Approx. 5 V
"B-1" and body ground: Approx. 5 V
"A-1" and body ground: Approx. 3 V
I2RH01010052-01
I2RH01010053-01
Precautions: 00-12
I5RH01000005-01