Set Mode: Signaling Menu Operations; Notification Of A Call From A Remote Station By The Bell; Selecting A Dcs Code; Transmitting And Receiving A Dcs Code With An Inverted Phase Dcs Inversion Function - Yaesu FT2DR Operating Instructions Manual

Set Mode: SIGNALING Menu Operations

Press and hold the
[SIGNALING] to set the individual items.
After completing the setup, press

Notification of a Call from a Remote Station by the Bell

Set whether or not to alert you of a call from a remote station using the bell by selecting
[1 BELL].
For details, see "Notification of a Call from a Remote Station by the Bell Function" on
page 114.

Selecting a DCS Code

Select the DCS code out of the 104 codes from 023 to 754 by selecting [2 DCS CODE].
For more details, see "Setting the DCS Code" on page 112.
Transmitting and Receiving a DCS Code with an Inverted Phase
DCS INVERSION Function
The transmit and receive DCS code phase may be inverted when using the digital code
squelch function.
1
Touch [3 DCS INVERSION].
2
Rotate the DIAL to select the phase combination for transmit/receive.
RX Homeomorphic / Both Phase / Inverted
Phase
TX Homeomorphic / Inverted Phase
Remark The default setting: Receive [Homeomorphic], Transmit [Homeomorphic]

Setting the Transmission Method of the DTMF Code

Set the transmission method of the registered DTMF code by selecting [4 DTMF MODE].
For details, see "Transmitting the Registered DTMF Code" on page 104.
138
key for over one second to display "SETUP MENU", then touch
to exit from Set mode.