Set Mode: Tx/Rx Menu Operations; Reducing Receiver Sensitivity Attenuator (Att) Function; Setting The Transmit Modulation Level - Yaesu FT2DR Operating Instructions Manual

Set Mode: TX/RX Menu Operations

Press and hold the
[TX/RX] to display the sub-menu items. Set each item under the sub-menu.
After completing the setup, press
Reducing Receiver Sensitivity
Attenuator (ATT) Function
If the signal from the remote station is too strong or, a strong signal exists nearby that
interferes with reception, use the attenuator (ATT) function to reduce interference by
selecting [1 MODE] → [1 ANTENNA ATT].
For details, see "Attenuator (ATT) Function (except AM broadcasts and AM broadcasts)"
on page 50.
Tip
The amount of attenuation by the attenuator (ATT) is about 10 dB.

Setting the Transmit Modulation Level

The transmit modulation level can be set to half of its usual level.
Select [OFF] for normal amateur operation.
1
Touch [1 MODE].
2
Touch [2 HALF DEVIATION].
3
Rotate the DIAL to select the desired setting.
OFF Normal transmission modulation level
ON The level is half of the normal transmit
modulation level.
Remark The default setting: OFF
132
key for over one second to display "SETUP MENU", then touch
to exit from Set mode.