Yaesu FT2DR Operating Instructions Manual page 80

Memory Channel Scanning
8
Press the
9
Touch [F MW].
10
Touch [BANK].
11
Press the
12
Rotate the DIAL to select the memory bank to begin memory scanning from.
The memory bank number is changed from [B] to [b] and
the bank link scanning is activated.
13
Press the
The memory banks for which you perform memory bank
link scanning are determined.
14
Touch [F MW].
The function menu screen appears.
15
Touch [SCAN].
Scanning is performed toward the higher memory
Tips •
channel numbers.
Rotate the DIAL clockwise: Scanning is performed
•
toward the higher memory channel numbers.
Rotate the DIAL counterclockwise: Scanning is performed toward the lower
•
memory channel numbers.
When a signal is received during scanning, scanning stops for 5 seconds and
•
this frequency is received.
When scanning is suspended, the decimal point blinks and the LCD stays lit.
•
After receiving the frequency for 5 seconds, scanning resumes.
•
To stop scanning, touch [STOP] or press
•
You can select the range for scanning by pressing and holding the
•
over one second to enter Set mode, then selecting
y Canceling Bank Link Scanning
1
Press and hold the
The transceiver enters Set mode.
2
Touch [MEMORY].
3
Touch [1 BANK LINK].
4
Rotate the DIAL to select the memory bank.
5
Press the
The memory bank display is changed from ☒ to □ and the bank link scanning is
deactivated.
6
Repeat steps 4 and 5 to select other memory banks.
7
Press .
The transceiver exits from Set mode.
80
key to enter Memory mode.
key.
key.
key for over one second.
key.
The memory bank number is
changed from [B] to [b]
.
[SCAN] → [5 SCAN WIDTH]
key for
.